(Psikyo 1995)
|
|
||||||||||||||||||||||
|
How
to use these Romsets with your PCB:
Your Strikers 1945 PCB should have 3 Eproms on sockets at the following positions: 2 of them are relevant for swapping the revision; the ones at position U40 and U41. If the eproms on your PCB are at different positions, it is not compatible with the Rom-Files provided here ! To create a new eprom set, take the 2 Rom-Files from the zip archive you downloaded from here and burn them on new Eproms of the same type using an eprom programmer. It should work by reburning the old Eproms too, if you properly erase them first. hints: A useful method to remove an eprom from a socket would be to stick a flat screwdriver between eprom and socket and then to rotate it carefully until it lifts both sides of pins out of their slots. Always keep an eye on the correct direction whenever you place a eprom into a socket (Look out for that small gap at one side of the chip. Find the same gap imprinted on the surface of the PCB) |
|||||||||||||||||||||||
